Being one of the basic bathroom necessities, if the bath shower mixer taps get leaky or show any other fault, it can become quite a hassle. If you are one of those, who love to take a warm shower every morning, you’d want to sort the malfunctioning right away. Bath Shower mixer taps often turn out various faults, most of which can be tackled at home with some basic know-how.
Importance of Bath Shower Mixer Taps.
It is needless to say that Bath shower mixer taps are very important to organize and control the flow of the water. Once these go out of order, you cannot take a bath or shower. In addition to their functional importance, one more thing that these are important for is aesthetics. Where these facilitate water control, you can also use them to improve the overall look of the bathroom.
Replacing The Bathroom Taps
The modern bathtub is versatile. These work as bathtubs as well as showers as well. In addition to that, these have various types too. From a single-ended with one side taps and double-ended where the taps are placed in the middle, there are many variations. Once you finally decide to replace the faucets, it is important to figure out what things you will require. Relacing a tap in comparison to a new installation is fairly easy if you have some understanding of working with different plumbing tools. You will need to try to get new faucets similar to the older ones in design and shape. Otherwise, the fixing may require some adjustments.
Step By Step Process of Replacing Bath Shower Mixer Taps
Here we have step by step process of replacing the Bath Shower Mixer Taps
Understanding the Fault
Before you start, it is important to know whether the tap needs a replacement, or if some fixing will do the job? Oftentimes people replace the entire set when a minor inconvenience shows up when all it needs is a little repairing. There are a few tricks to figure out what type of solution would work in your case.
The first thing you need to do is identify which part of the set is leaking. The showerhead, hose, and valve turn out to be the culprits in most cases. Here are the tools you would need to fix the problem.
- Pliers
- Screwdriver
- Washers
- Seal tape
- Plumbing putty
Step by Step Process
- Shut Down the Water Supply of your bathroom by turning off the water mains. The switch-off valve is often located under the sink in most homes; if not, try finding it in the basement or an airing cupboard.
- Open the Bathroom taps using pliers and let the water in the pipes drain out. The water in the mains must drain out for you to fix the taps easily.
- Detach the mixer bathroom taps with the help of a screwdriver after the water has escaped through the pipes.
- Examine the gasket – a rubber ring attached near the valve. Inspect the gasket for any wear and tear so you can figure out whether it needs to be replaced. If the gasket is the cause of leakage, remove it and use the plumber putty instead which acts as a waterproof sealant.
- Replace all the washers installed at the end of the shower stem. Take off the lid and the shower hose, and replace all the rubber rings with newer ones. This will help relieve the pressure. Also, remember to check if the shower stem is damaged.
- Unclog the pipes before installing the valve back to restore the water flow.
- Fasten the shower bath mixer tap back to the pipe just the way you removed it. Don’t forget to tighten it thoroughly to prevent any leakage.
- Restore the water supply and check if there is any leakage or not.
Getting High Quality Bath Shower Mixer Taps
In this article, we have a discussion about Bathroom Taps. We also have a discussion about different things that you will need to replace buy taps Online . Follow these step-by-step process, you can do it yourself. it is better to always hire an experienced plumber for the job. Especially in case, you don’t have any experience of working with plumbing tools. At Royal Bathrooms online store in the UK, we have different types of fittings and fixtures available at lower prices.